Tuning effect of silicon substitution on magnetic and high frequency electromagnetic properties of R2Fe17 and their composites

In this work, we report the tuning effect of the Si substitution on the magnetic and high frequency electromagnetic properties of R₂Fe₁₇ compounds and their paraffin composites. It is found that the introduction of Si can remarkably improve the magnetic and electromagnetic properties of the R₂Fe₁₇ compounds, making the R₂Fe_17–xSi_x-paraffin composites excellent microwave absorption materials (MAMs). By introducing the Si element, their saturation magnetizations decrease slightly, while much higher Curie temperatures are obtained. Furthermore, better impedance match is reached due to the decrease of the high-frequency permittivity ε′ by about 40%–50%, which finally enhances the performance of the microwave absorption. The peak frequency (f_RL) of the reflection loss (RL) curve moves toward high frequency domain and the qualified bandwidth (QB, RL ≤ ?10 dB) increases remarkably. The maximum QB of 3.3 GHz (12.0–15.3 GHz) is obtained for the Sm_1.5Y_0.5Fe₁₅Si₂-paraffin composite (d = 1.0 mm) and the maximum RL of ?53.6 dB is achieved for Nd₂Fe₁₅Si₂-paraffin composite (d = 2.2 mm), both surpassing most of the reported MAMs. Additionally, a distinguished dielectric microwave absorption peak is observed, which further increases the QB in these composites.     

0.88C-1.2Si-0.75Mn-2Al高强度电缆铠装钢用盘条的试制

采用中高碳成分添加低密度元素Si、Al进行轻量化的设计思路设计了试验钢的化学成分,试验钢采用50 kg真空感应炉冶炼。利用金相显微镜、SEM扫描电镜和力学性能检测设备对试制后的Φ6 mm盘条进行了显微组织观察、珠光体片层间距的测量和屈服强度、抗拉强度、延伸率的检验。结果表明:盘条在600℃等温2 h后的金相显微组织为铁素体+珠光体的混合组织,珠光体的片层间距为(126±5) nm,屈服强度大于1 183 MPa、抗拉强度大于1 425 MPa、延伸率大于10%,其力学性能满足电缆用铠装钢的技术要求。     

亚波长光栅用于实现宽光谱消色散1/4波片的研究

基于严格耦合波理论 ,分析了共振区域矩形位相光栅的衍射特性 :位相延迟与光栅周期、占空比、槽深的关系 ,并设计出在 40 0～ 80 0nm范围内的消色散 1/4波片光栅 ,可以实现较为平坦的衍射效率和位相延迟曲线 ,其中位相延迟可保持在 90°左右 ,最大偏差小于 9% ,达到甚至优于普通二元复合消色散波片。通过对加工及安装误差的讨论 ,得到了影响消色散波片光栅性能的主要加工误差是槽深误差和占空比误差。     

Structure, properties, and thermal stability of nanocrystallite Fe-Ti-N soft magnetic films

We deposited Fe-Ti-N magnetic films with a high sputtering power of 7 W/cm/sup 2/. When the composition of the films was in the range of Fe-Ti(3.9 at.%)-N(8.8 at.%) to Fe-Ti(3.3 at.%)-N(13.5 at.%), the films were composed of /spl alpha/' and Ti/sub 2/N precipitates. With the addition of nitrogen, 4/spl pi/M/sub s/ became higher than that of pure iron, reaching a maximum of 23.8 kG. At the same time, H/sub c/ was reduced to a minimum of 1.12 Oe. The best films can meet the needs of the recording head in dual-element giant magnetoresistive/inductive heads, yielding high storage density (10 Gb/in/sup 2/). The incorporation of N in /spl alpha/-Fe brought about the /spl alpha/' phase with its higher saturation magnetization. Ti additions inhibited the equilibrium decomposition /spl alpha/'/spl rarr//spl alpha/+/spl gamma/'. Because H/sub C//sup D//spl prop/D/sup 6/, where D is average grain diameter, grain size control is very important. The nitrogen induces severe distortion of the /spl alpha/' lattice, which can cause the grains to break into pieces and reduce the grain size. High sputtering power also led to the formation of fine grains, with diameter in the order of 14 nm. Probably Ti/sub 2/N is preferentially precipitated on the grain boundary, pinning the grain boundary and stabilizing the grain size during high-temperature heat treatment. The temperature limit for stability of the structure and its associated low coercivity was not less than 520/spl deg/C.     

Synthesis and Interfacial Tension Behavior of Heavy Alkyl Benzene Sulfonates

Heavy alkyl benzene sulfonates (HABS) were synthesized, and their interfacial tensions were measured and compared with those of petroleum sulfonates ORS-41. Effects of their coupling with lignosulfonate were also studied. The results showed that HABS exhibited good interfacial activities and the system of HABS blending with LS displayed better interfacial activities than ORS-41 and therefore reduced the prime cost. Their best proportions of synergism were from 3:1 to 4:1. HABS might be a more promising alkali-surfactant-polymer (ASP) flooding agent.     

智能动态网络资源分配系统

通过对解决GSM移动通信网络热点区域话务拥塞问题的研究，提出了利用可控功分器实现智能动态网络资源的分配，解决不同种类的话务拥塞问题，并着重讨论了该系统目前的成功运用及前景。     

锂离子电池用聚合物电解质的最新进展II.含液聚合物电解质

由于干态聚合物电解质目前还不能满足聚合物锂离子电池的应用要求,人们致力于开发含液体增塑剂的聚合物电解质,包括凝胶型和微孔型两类体系。本文综述了含液聚合物电解质的最新进展,重点论述了各种新体系和新方法。     

具有阻力特性材料的σ_f－σ关系及一种新的阻力曲线测定方法

通过对相变增韧陶瓷及一种可切削玻璃－陶瓷动态疲劳（恒应力速率）试验中高应力速率区断裂应力下降现象的理论分析，发现这种现象与材料的阻力特性（Ｒ－ｃｕｒｖｅ）密切相关。确立的σ_ｆ－σ理论关系能够很好地描述整个应力速率区间内的动态疲劳试验结果。高应力速率区σ_ｆ－σ在双对数坐标下为负斜率直线，直线斜率为（ｍ为阻力曲线ＫＲ＝ｋ（△ａ）~ｍ的指数），断裂主要由材料阻力行为控制；低应力速率区，σ_ｆ－σ在双对数坐标下为正斜率直线，直线斜率为　（ｎ为应力腐蚀指数），断裂主要由材料应力腐蚀行为控制。建立了测定材料阻力特性的一种新方法，分别用这种方法及压痕／弯曲方法对一种可切削玻璃－陶瓷的阻力特性进行了实验测定，两种方法所得结果有很好的一致性。     

Optoelectronic buses for high-performance computing

Modern computer buses are typically organized by the three functions of data transfer, addressing, and arbitration/control. In this paper we present a fiber-based bus design which provides optical solutions for each of these functions. The design includes an all-optical addressing system, based on coincident pulse addressing, which eliminates the latency contribution and bandwidth limitation associated with electronic address decoding. The control system uses time-of-flight relationships between a priority chain and a feedback waveguide to implement fully distributed asynchronous and self-timed bus arbitration     

һ����ӱ����˹����ȼ����ȼ�Զ���Ͽ���װ��

我国是煤资源大国，长期来在采煤的同时，抽放排空大量煤层瓦斯，不仅浪费大量资源，还严重污染大气。利用煤层瓦斯发电是解决煤层瓦斯放空的重要途径 。文章介绍一种全新的有别于传统 发动机的瓦斯内燃机空燃自动混合控制装置，其中包括：煤层瓦斯的理化特性、装置的结构、工作原理及工作过程，阐述了结构参数对发动机性能的影响。经过在中心瓦斯工区内燃发动机组群上安装试运行，结果表明：该装置可以适用于高、中、低不同浓度的煤层瓦斯，性能稳定、可靠，达到了设计性能指标，完全满足燃气,内燃机组的使用要求，并取得了很好的经济效益、生态效益和环保效益。